Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateGate Company in Highland, CA
Gate installation in Highland usually runs between $1,800 and $9,500 depending on whether you’re replacing a tired driveway gate or building a full automatic entry system with new posts, motor, and access controls. Most of the gates we install in Highland go into homes built between the 1960s and 1990s, where the original ornamental iron or chain-link gates have outlived their hardware. Because Highland sits on decomposed granite and expansive clay at the base of the San Bernardino Mountains, we almost always re-set or re-concrete the posts before hanging a single piece of steel. Call (866) 893-2220 if you’re sizing up a replacement and want a straight answer on what your lot actually needs.
Why Highland Homes Are Different
Highland’s gate problems follow a pattern we don’t see the same way in San Bernardino or Redlands. The soil east of the 210 freeway is sandy granite that drinks water differently season to season. A dry summer bakes it hard, then the first hard October rain makes it swell and shift, and a gate that latched fine in September suddenly hangs 1/4 to 1/2 inch low. That’s not a hinge problem. That’s the post moving in the ground, and the only real fix is pulling it, re-setting it in fresh concrete, and sometimes pouring a deeper footing than the original builder bothered with.
The housing stock complicates things further. Highland’s tract homes from the 1960s through the 1990s were built with masonry pilasters or wood fence lines that the gates were mounted into. When the pilaster cracks or the fence post rots, the gate can’t be re-hung until that structure is repaired or rebuilt. Off-the-shelf hardware rarely matches what was installed forty years ago, so we fabricate or source period-appropriate brackets, hinges, and latch sets rather than forcing a modern conversion that looks wrong against an older home. Then there’s the climate. Summers over 100°F with UV pouring through the Cajon Pass corridor dry out wood gates until they crack, warp vinyl, and loosen anchors as steel expands and contracts. The combination of shifting soil and sun-baked materials means installation in Highland starts with the footing, not the gate.
Styles & brands we work with
Our Main Highland Services
Homeowners in Highland call us for two things more than anything else: a gate that won’t open or close correctly, and an electric operator that has stopped responding. Here’s how each plays out in this city specifically.
Gate Repair in Highland
Mechanical gate repair in Highland is usually about alignment before hardware. The sandy foothill soil lets posts drift, so a sagging gate often needs the post re-set rather than the hinges replaced. Wood gates split and warp from the dry heat, which pulls latch and hinge geometry out of true. We repair gates in Highland with the same brand-agnostic approach we use everywhere: diagnose first, replace only what’s needed. The full breakdown of repair work is on Gate Repair in Highland.
Electric Gate Repair in Highland
Electric gates fail differently here than in coastal cities. Highland’s heat and wind press dust into motor housings and control boards, and the seasonal soil movement puts sensors out of alignment even when the gate itself still swings. We work on the brand you already have, from the motor to the control board, whether that’s a LiftMaster, Viking, or Ghost Controls operator. For the deeper dive into automation failures and diagnostics, see Electric Gate Repair in Highland.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Gate Installation in Highland
A new gate in Highland is a footing job before it’s anything else. The decomposed granite under Highland’s 1960s – 1990s tract lots shifts seasonally, and gates set into shallow concrete from decades ago have moved so far out of plumb that no hinge adjustment can compensate. We pour deeper footings and re-align the entire opening, then hang a gate matched to the house’s era and fence line so it doesn’t look like a bolt-on afterthought. Most homeowners have no idea what their lot and gate style will cost until someone looks at the posts, which is why we quote everything in writing before work begins. Our full process is covered on the Gate Installation page.
Automatic Gate Installation
Signs you need it
You’re opening and closing a heavy gate by hand every day, the existing operator is mechanically worn or electrically dead, or you want keypad and remote access for a driveway that currently relies on a manual latch.
What it costs in Highland
In Highland, automatic gate installation ranges from $2,500 for a simple single-swing retrofit on an existing sound post to $9,500 for a full dual-leaf system with a new motor, receiver, and power run.
How we do it
We start by checking the existing posts and footings, pour or rebuild as needed, mount the operator, run the low-voltage wiring, install the receiver and safety edges, and program the remotes before testing full open and close cycles.
Driveway Gate Installation
Signs you need it
Your current driveway gate drags on the ground, won’t stay latched through the October soil shift, or was damaged beyond economical repair and needs to match an older fence and pilaster style.
What it costs in Highland
This work runs $1,800 to $3,800 for a single manual gate on sound existing posts, and climbs to $4,500 – $9,500 when the job includes new automatic hardware and a motor.
How we do it
We remove the old gate and decayed hardware, set or re-concrete the posts, hang the new gate with fresh hinges and a latch matched to your fence line, then adjust the gap so it clears the drive cleanly through every season.
Sliding Gate Installation
Signs you need it
Your driveway slopes or has a short setback that makes swing gates impractical, or you want the clean, space-saving operation of a slide track across a wider opening.
What it costs in Highland
Highland sliding gate installations typically range from $2,500 to $6,500 depending on gate length, whether the motor is included, and the amount of grade work the decomposed granite soil requires.
How we do it
We set the steel posts and lay the track on a properly compacted base, hang the gate, install the operator and stops, and fine-tune the wheel and track alignment so it rides without binding.
What Gate Installation Costs in Highland
| Item | Typical range in Highland |
|---|---|
| Manual gate on existing posts | $1,800 – $3,800 |
| Automatic gate with motor | $2,500 – $9,500 |
| Sliding gate with track and operator | $2,500 – $6,500 |
Do I need a permit for a new automatic gate in Highland?
In most Highland residential cases a like-for-like gate replacement doesn’t trigger a permit, but new motorized entries and any electrical run can require city approval depending on the scope. We’ll check current city requirements before submitting work and tell you if anything needs filing before we start.
How long does a gate installation take in Highland?
Most single driveway gates go from removal through concrete setting to a finished, operating gate in one to three days. Jobs that include new footings deep enough to handle Highland’s shifting granite soil can add a day for curing before we hang the gate and tune the hardware.
Brands We Service in Highland
We work on the gate operator you already have rather than steering you toward a single line. In Highland that commonly means older Linear and Viking boards in 1990s tract homes, plus DoorKing and Ghost Controls units on newer estate properties. Our truck stock carries boards, remotes, and receivers for all of them, and a full list lives on our brands page. If a board is on the shelf, we’re usually finished the same visit.
See the difference
Before
After
Before
After
Before
AfterPricing for Gate Company in Highland, CA
| Service | Typical range in Highland |
|---|---|
| Gate installation | $1,800 – $9,500 |
| Automatic gate installation | $2,500 – $9,500 |
| Driveway gate installation | $1,800 – $9,500 |
| Sliding gate installation | $2,500 – $6,500 |
| Gate repair – mechanical (hinge, latch, sag) | $180 – $450 |
| Electric gate repair – electrical component | $220 – $600 |
| Circuit board replacement | $280 – $1,050 |
| Motor replacement | $450 – $2,200 |
| Gate post re-set / re-concreting | $350 – $800 per post |
| Roller / track replacement | $180 – $500 |
| Safety sensor replacement | $150 – $450 |
| Complete electric gate system replacement | $2,800 – $9,500 |
Two things push a Highland quote above the midpoint: a post that has sunk or leaned so far the footing has to be dug out and re-poured, and an older operator whose replacement board is no longer manufactured and has to be sourced or cross-matched. Every price is agreed in writing before we order parts or put a tool to the gate, so the number you approve is the number on the invoice.
Neighborhoods We Serve in Highland
We work across the 92346 ZIP and the surrounding blocks of Highland throughout the year. Most of our calls come from the older tract streets east of the 210, plus the newer subdivisions farther toward the foothills where soil movement is more aggressive. Typical response to Highland is same-day for gate repairs when the call lands before mid-afternoon, with installation visits scheduled around concrete curing time.
- East Highlands
- Highland Village area
- Along Base Line and the neighborhoods off Victoria
- Foothill lots near the San Bernardino National Forest boundary
- Streets north of Highland Avenue toward the 30 freeway
Service Area – Cities Near Highland
Estate Gate Repair serves Highland and works throughout the neighboring Inland Empire communities. If you’re just across the line in San Bernardino, CA or Muscoy, CA, the same gate-only technicians handle your repair. We also cover Redlands, CA to the east and Loma Linda, CA to the south, with the same brand-agnostic diagnostic approach in every city.
Serving Highland, CA — Our Local Coverage Area
We’re based in the Highland area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Highland
Most Highland repair calls are reached the same day when they come in before mid-afternoon, because our technicians are already working across the 92346 ZIP and the Inland Empire. Electric gate failures that strand a car in the driveway are our first priority, and the diagnostic itself typically takes under an hour.
Some Highland neighborhoods with newer developments have architectural committees that require specific gate heights, colors, or materials, and a few of the older tract HOAs still enforce original style standards. If your home has an HOA, we’ll work from their written requirements before ordering anything so the installation doesn’t get rejected at the first glance.
Yes. Highland has a large stock of mid-century tract homes with original ornamental iron that was built into masonry pilasters, and modern replacements often look too light or too modern against those lines. We source period-matching steel, pickets, and hardware, and our fabricator replicates the original thickness and spacing so the new gate reads as original to the house.
If your gate has dropped, your motor has quit, or you’re ready to replace the whole entry, call (866) 893-2220 for a free estimate. We’ll look at the posts first, because in Highland that’s where the problem usually starts.
What happens when you call
- 1A real person answersNo phone trees — talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Highland Customers Say
"The loop detector under the driveway had failed and residents were stuck holding the button. He traced it, found the break, and had the exit loop reading cars again the same visit."
— Daniela Ramirez"Control board fried after a lightning storm. He showed me the burn mark on it, quoted the board, and installed a surge protector on the line so it hopefully doesn't happen again."
— Sarah Novak"We had a hydraulic arm leaking fluid onto the driveway. Replaced, cleaned up the stain as best he could, and it's been dry for months."
— Ramon Hernandez